Bryant NON-PROGRAMMABLE THERMOSTAT Manuale delle Istruzioni Scaricare il pdf (Pagina 21)

5. Match and connect equipment wires to proper terminals of each connector

block.

6. Push any excess wire into wall and against Equipment Control Module.

Seal hole in wall to prevent air leaks. Leaks can affect operation and cause

incorrect temperature and/or humidity measurement.

7. Remove 2--wire pigtail from thermostat mounting base and attach to

Equipment Control Module terminal block (terminals V+ and Vg). Attach

two-- wire pigtail to the back of the Display Module via 2 pin, keyed con-

nector.

8. Reattach Display Module body to Equipment Control Module by first

setting on at top and then push bottom corners to snap into place. See Fig.

15.

A07221

Fig. 15 -- Reattach Display Module

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Nessun commento

Bryant NON-PROGRAMMABLE THERMOSTAT Manuale delle Istruzioni Pagina 21