Bryant 4-Way Multipoise Fixed-Capacity Direct-Vent Conden Manuale Utente Scaricare il pdf (Pagina 14)

A02204a

Is LED status light on?

Is LED status light blinking rapidly without a

pause?

Is LED status light blinking ON/OFF slowly

with a combination of short and long flashes?

Determine status code. The status code is a

2 digit number with the first digit determined

by the number of short flashes and the second

digit by the number of long flashes?

Go to section below for the status code that

was flashed.

Is there 115V at L1 and L2?

Is there 24V at SEC-1 and SEC-2?

Replace furnace control.

Check for correct line voltage polarity. If units

are twinned, check for proper low-voltage

(24V) transformer phasing.

To recall status code briefly remove and reconnect one RED wire from the Limit

Switch or Flame Rollout switch to display stored status code. On RED LED

control do not remove power or blower access panel before initiating status

code recall. You can also recall the previous status code by momentarily shorting

the TEST/TWIN terminal to Com24V terminal until the LED goes out. LED will

flash the previous status code or status code #11 (1 short and 1 long flash) if

there was no previous code. After the control repeats the code 4 times, the

control will go through a brief component test sequence. The inducer will start

and run for the entire component test. The HSI, blower motor FAN speed

(AMBER LED boards only) HEAT speed, and COOL speed will run for 10 – 15

seconds each. Gas valve and humidifier will not be turned on.

Was there a previous status code

other than #11?

Is door switch closed?

Is there 115V going to switch?

Replace door switch.

Replace transformer.

Does the control respond to W, Y1 (if present),

Y/Y2, and G (24V) thermostat signals?

Run system through a heating or cooling cycle

to check operation. Status codes are erased

after 72 hours. On RED LED boards stored

status codes can also be erased whenever

(115V or 24V) is interrupted.

Replace furnace control.

Close door switch and go back to START.

Is circuit breaker closed?

Check for continuity in wire from circuit breaker

to furnace.

Close circuit breaker and go back to START.

Check room thermostat or

interconnecting cable.

Is 24V present at W, Y1 (if present), Y/Y2 or

G thermostat terminals on the furnace control?

Disconnect all the thermostat wires from the

furnace control.

Does the problem repeat when using

a jumper wire?

The thermostat is not compatible with the

furnace control. Either install a ballast resistor,

connect the Com24V thermostat terminal to

the thermostat, or replace the thermostat.

YES

START

TROUBLESHOOTING GUIDE

—14—

1 2 ... 9 10 11 12 13 14 15 16

Commenti su questo manuale

Nessun commento

Bryant 4-Way Multipoise Fixed-Capacity Direct-Vent Conden Manuale Utente Pagina 14

Commenti su questo manuale

Prodotti e manuali riguardandi Forno Bryant 4-Way Multipoise Fixed-Capacity Direct-Vent Conden